TISSUE PACK WRAP TUTORIAL
By Barbara Welch, Creative Stampin' Spot
As I promised yesterday, the Tutorial is ready to go. I was inspired by a demonstrator at convention who made these. I basically measured the pack of tissues I purchased and then made my pattern
Things you will need:
Stamp Sets I used Snow Buddies, Serene Snowflakes, Teeny Tiny Wishes
Ink: Basic Grey, Bashful Blue
Markers: Bashful Blue, Certainly Celery, Only Orange
Base (Bashful Blue shown) 4-1/2" x 8-1/2"
Whisper White layer (shown stamped with snowman) 1-5/8" x 1-7/8"
Brocade Blue layer 1-3/4" x 2"
Ribbon - 15"
Pocket Pack of Tissues
Scallop Oval or Large Oval Punch
Begin by cutting the Bashful Blue Cardstock to 4-1/2 x 8-1/2"
If using a scoring board, score along the 8-1/2" edge as follows:
2" - 3" - move left edge of paper to 1/4" mark and score at 5-1/2" - 6-1/2"
If using a Bone Folder with a ruler, use the marks on the grid paper, score along the 8-1/2" edge as follows:
2" - 3" - 5-1/4" - 6-1/4"
Stamp the Snowflake images using Bashful Blue Ink onto the Bashful Blue cardstock. I used the three different images and did random stamping all over.
Use an Oval Punch to punch an opening in the center of the largest end panel (2-1/4")
Place sticky strip on the underneath (unstamped) side along this edge.
Place Ribbon in the middle portion of the cardstock and tie a knot on top closer to the right side.
Stamp the "get well wishes" under the knot but above the score line.
Fold along all score lines; using a pencil, mark where the oval should be punched on the other end panel.
Punch the oval.
Now you are ready to assemble
Place the tissue pack in the center
Fold the shortest end in first
Remove the protective cover from the sticky strip adhesive
Then fold the largest (2-1/4") end over on top of the smaller panel and making sure to align the ovals. Press to adhere.
Here is the front/top view
Here is the back view with the tissues pulled through
I stamped the snowman in Basic Grey and colored in the images with markers.
Then mounted this onto the Brocade Blue layer. Using Stampin' Dimensionals, adhere this to the top over the ribbon.
Thanks again for stopping in to check out my tutorial for making the TISSUE PACK WRAP.
Did you like this tutorial? Please leave a comment for me if you did.
I would love to see what you create using my tutorial, please leave a comment with a link to the location for me to take a look.
Live, Laugh, Love and STAMP!!!